Services / Fences / Gate Installation & Repair
Gate Installation & Repair in Buffalo, NY
A gate that drags, sticks, or won’t latch is almost always a hardware or post problem, not a reason to replace the whole thing. We size hinges, latches, and drop rods to the gate’s actual weight, reinforce the post if that’s what’s causing the sag, and build or repair the frame square so it swings true again.
What’s included
Every job starts with a design or assessment visit and ends with a clean, cleared-up yard. In between: permits pulled where needed, inspections passed, and work we photograph for your records.
Hardware sized to the gate
Hinges, latches, and drop rods matched to the gate’s actual weight and use.
Post reinforcement
Gate posts checked and reinforced or reset if they’re the reason a gate sags.
Square framing
Gates built or repaired square so they swing true, not diagonal.
Self-closing options
Hydraulic hinges and closers available where code or convenience calls for it.
Drive gate options
Manual and motor-ready drive gates for wider openings.
Final adjustment & walkthrough
Swing, latch, and clearance checked before we call it done.
Free, written quote
Gate repairs typically run $200 to $900; new gate installation varies with width and material. Free on-site quote, itemized in writing.
Assessment, quote in 48 hrs
Most jobs: same day to 1 day on site
0% APR financing for 12 months available
★★★★★
“Every post is still plumb after two winters. The gate still swings the way it did the day they hung it.”
Rob & Denise L. · Lancaster
Process
From first call to done right, in four steps.
Step 1
Free assessment
We check the gate, posts, and hardware to find the actual cause of the problem.
Step 2
Written quote
Itemized, within 48 hours.
Step 3
Schedule the work
Most jobs book within a week.
Step 4
Install & walkthrough
Same-day to one-day turnaround with a final swing-and-latch check.
Gate Installation & Repair FAQs
Why do gates start to sag?
Almost always a post that was not set deep enough or hardware that was undersized for the gate’s weight. We size posts and hinges for the actual gate, not the smallest option that will pass at first.
Do fence posts really need to go below frost depth?
For anything permanent, yes. A post set shallow will heave with the freeze-thaw cycle and lean within a couple of winters. We set posts below the 48-inch frost line the same way we do for deck footings.
Is the quote really free?
Yes. A visit takes about an hour, and the written quote arrives within 48 hours. It’s valid for 60 days and there’s no pressure follow-up.
What warranty comes with the work?
10 years on workmanship for new builds, 2 years on repairs, plus manufacturer warranties on boards, up to 50 years on some composites. Both in writing with the quote.